+ Reply to Thread
Results 21 to 30 of 54
09-30-2011, 11:23 AM #21
I am not found of the piping on the card, but really appreciate the work.
However, do you simply glue back the door card or do you have a wizard technique to screw it back, then cover the lower screws ?
Please post pics of its console and dashboard.
Also please note it is called a Range Rover "L322" (manufacturer code name), the term "Vogue" being a trim level, not a model (bar Australia that indeed use the term "Vogue" for the L322 - I know this is confusing... )
Thanks for sharing !
09-30-2011, 01:04 PM #22
Its a hell hard job to separate door cards and put them back together, there is no screws or nuts, they are hot melted together, only way to separate them is to use hammer, chisel and knifes, basicly must use a lot of force to work them.
09-30-2011, 01:10 PM #23
I meant when you put them back on the door itself, there are screws to hold the card to the door, including two all the way at the bottom.
On your pics one can -just- see that leather covers the screw holes, hence my question, how do you do that, if you do screw the card bat on the door?
Sponsored Links Remove Advertisements
09-30-2011, 01:18 PM #24
He must not have used the screws again. There are still pins that secure the panel to the door.
YMBRE: You should get a plastic welding tool if you dont have one. Would make taking the panels apart a lot easier. We heat the welds up to pull the panels apart and then just plastic weld them back together for a factory fit...
09-30-2011, 01:22 PM #25
Nice to see potential "competitors" giving each other tips, L4Play community is awesome.
09-30-2011, 01:30 PM #26
Very nice work brotha!Hidden Content
RDB LA | Five Star Tires
7318 W Sunset Blvd.
Los Angeles, CA 90046
Instagram feed: @rdbvik
Collision & Car Customization Center, Full Auto Repair Service Facility, PPG Paint Specialists. Over 30 years of expert experience in auto body repair, paint & custom work. RDB specializes in luxury & exotic vehicles & our attention to detail is guaranteed!
09-30-2011, 01:40 PM #27
Yes like Infamous says, I dont need to use this screw you talking about , because pins holds card so well even without it, that was also customers wich too to keep it without that hole
Infamous: You mean some hot air blower? yes I have those too, but only use this was`nt enough at this time. Thanks for mention of course. Second time I consider use some other technique, course every time I do that I still learn something.
09-30-2011, 02:17 PM #28
09-30-2011, 06:37 PM #29
where are u based out of? i need an interior change for my 06 RRS.
10-01-2011, 03:07 AM #30
He is based out of Europe (Estonia)KpAi81
2006 Range Rover