Thread: Maserati MC - Project of the Week - No Kidding

We also took a video (on a different car with PhotoSync65) to show how well Prestige Film Technologies PhotoSync works with a BTU meter test (measuring heat transmittance). This is measured from a R8 GT passenger side with the windows rolling up and down to demonstrate the effectiveness of PhotoSync

Can you spot our Passport 9500Ci rear laser jammer? Probably not at first glance. We created a custom license plate frame / box to integrate the unit. Most 9500Ci rear jammers are just bolted on top of the license plate frame....too visible! Not here at Premier!

Another test performed and this is to test the varying line of shades of PhotoSync to a very popular ceramic based 40% tint

**PhotoSync45% was installed to the Maserati

Another test we conducted recently. With Prestige Film Technologies' Spectra PhotoSync Nano Window Film. We decided to document this test to show how well this product performs compared to a leading 30% ceramic tint. The previous test was done compared to a ceramic 40%. Test specs:

Spectra PhotoSync 65% (yes, we are using a lighter film to compare with a darker 30% ceramic tint)
*product to the left

VS.

30% Ceramic (one of the more popular ceramic tint products on the market....sorry, we are not going to name the manufacturer of this product, but can say it is likely the most well-known on the market)
*product to the right

Conditions:

Outdoor Temperature: 75 degrees

Test Time: 2pm

Measurement Equipment: BTU Meter aimed directly at the window films to obtain simultaneous readings for accuracy

Test Subject: Raging Gray Bull named the Aventador

Originally Posted by Plackslayer

Can you elaborate for us uninformed please?

The diffusers work best if they are mounted above the front license plate (if applicable) and as even with the headlights as you can. Now, in all vehicles this isnt possible because of the way the car is designed or what the client prefers. For function reasons alone it would have been better to mount them in front of the mesh grill so they would have as little obstruction as possible.

Originally Posted by TheEngineer

The diffusers work best if they are mounted above the front license plate (if applicable) and as even with the headlights as you can. Now, in all vehicles this isnt possible because of the way the car is designed or what the client prefers. For function reasons alone it would have been better to mount them in front of the mesh grill so they would have as little obstruction as possible.

Thank you for the clarification. I appreciate it.

Nice work Premier! I especially like how all the laser jammers were hidden! Definitely not noticeable until you inspect it longer!

Originally Posted by NorCal510

Nice work Premier! I especially like how all the laser jammers were hidden! Definitely not noticeable until you inspect it longer!

Thank you! When it comes to laser jammers + radar detection, we purposely install it to be flush mounted in areas where its performance criteria are not hindered, yet not overly visible to affect the aesthetics of any car.

To note, this video below shows how PhotoSync compares to a very popular ceramic 40% tint. However, this comparison was done at Spectra PhotoSync's pre-activation phase. In short, PhotoSync's Solar Adaptive Coating did not activate to produce maximum heat rejection, which means it will perform even better when exposed to solar energy for approximately 15 minutes.