Street Dreams Detail - 2013 Audi RS5 & 2013 C63 AMG Black Series - Both Black Full Paint Corrections!

+ Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: Street Dreams Detail - 2013 Audi RS5 & 2013 C63 AMG Black Series - Both Black Full Paint Corrections!

          
   
  1. #1
    DetailDave is offline Senior Member
    Join Date
    Nov 2008
    Location
    Northern NJ
    Posts
    1,486

    Default Street Dreams Detail - 2013 Audi RS5 & 2013 C63 AMG Black Series - Both Black Full Paint Corrections!

    Last month I detailed two of Germany's newest super coupes, the new C63 AMG Black Series Mercedes and a 2013 Audi RS5.

    Nice to finally have the RS5 in the states! Both cars were poorly prepped by the dealer and had some factory finishing issues which needed to be corrected. The goal for both vehicles was a proper new car preparation and 100% level paint correction to remove all the defects and restore maximum gloss and clarity.

    First, C63 Black Series:

    Prep consisted of 2 bucket wash, Iron Cut, Sonax wheel cleaner and the Nanoskin autoscrub clay disc.

    The overall finish of the Mercedes, as with most Mercedes was farily good. There are two main reasons for this: one is Mercedes very hard ceramic clear coats (more resistant to wash marring) and the other is high quality finishing from the factory. The Black Series may be considered and exotic auto but it is still very much a Mercedes Benz and you'll notice very few if any Mercedes driving around with factory installed holograms or sanding marks, on the Ferrari's, Astons and Lambo's however these defects come standard on every new model :shakehead:

    Not too much factory defect and luckily just some marring from the dealer prep

    Lower carbon fiber spoiler corrected first with the Flex rotary and an orange cutting pad with Menzerna Super intensive polish @ 1200-1500rpm



    Front fender some light holograms and light RIDS shown under the LED light, reasons to avoid a dealer prep at all costs







    After correction



    Carbon fiber splitters corrected with rotary as well..



    Before



    During



    After





    After final polishing all the other areas were handled as needed. Cleaning the matte finish wheels here using Swissvax Opaque pre cleaner..



    Engine detailed and all plastics dressed with 303 protectant



    All finished, only took 18hours to get it perfect!






  2. #2
    DetailDave is offline Senior Member
    Join Date
    Nov 2008
    Location
    Northern NJ
    Posts
    1,486

    Default

    Some sun shots..











    LSP of choice was Wolf's Bodywrap (Hard Body had not come in yet) but the BW still looked the business (you Chris Harris fans will appreciate such a remark)

    After the sun went down the finish still looked incredible, the metallic flake may not be popping here like it was in sunlight but the depth and clarity remains fantastic..












    Last shot of the evening..



  3. #3
    DetailDave is offline Senior Member
    Join Date
    Nov 2008
    Location
    Northern NJ
    Posts
    1,486

    Default

    Next... 2013 Audi RS5 in brilliant black metallic

    This is one of those cars I was hoping to get my hands as soon as it came out, it's absolutely beautiful (more so after some polishing work)



    The RS5 had been buffed at some point, RIDS and wool pad holograms all over the paint

    This is what I refer to as "holo-grimey"



    Decklid section wool holograms



    50/50 after compounding, gloss improved already and this was simply after Meguiars M105 compound no finishing work done yet. At this point I had a feeling I could take the brilliant black to another level, the amount of gloss that came out after only 1 step was very impressive. Some fine finishing work was sure to kick it up one more notch.



    Under the LED



    After finishing with PO85rd on the rotary, flake looking as it should now still no LSP



    Rear bumper had a good amount of issues as well..







    After correction the car was wiped down with Eraser to remove all polishing oils and prep the finish for LSP which was Wolf's Hard Body sealant. I applied this with a DA machine using a black pad on speed 2 left to sit for 15 minutes and then went on to detail the rest of the car. A second coat was applied a few hours later.

    Interior was still in new condition so the leather was gently cleaned and hard plastics protected with 303. Doorjambs sealed using Aquartz Reload.



    Final shots, I took a bunch of photos of the metallic flake up close it just popped off the paint I could not resist, 3.5hrs of fine polishing has its benefits!











    Wheels sealed with Aquartz reload and tires dressed for a dark matte gloss


  4. #4
    DetailDave is offline Senior Member
    Join Date
    Nov 2008
    Location
    Northern NJ
    Posts
    1,486

    Default

    The metallic flake truly was some of the best looking I have seen out in the sun, it just popped from every angle















    Thats all for now will work on getting some more writeups soon. Thanks for reading as always!

    Regards,

    Dave Saunders
    Street Dreams Detail

  5. #5
    Envious Eric's Avatar
    Envious Eric is online now Detail Sponsor
    Join Date
    Feb 2009
    Location
    Orange County, CA
    Posts
    1,285

    Default

    looking good man! One of my clients was in the market for a RS5 and the dealership didnt know when they would be getting another, but he needed a car, so he ended up with the S5...still a very stylish car!

    Cars look sick!
    Vehicle Reconditioning and Paint Correction Detailing Services
    Orange County, LA County, San Diego County, Riverside County
    www.enviousautodetailing.com
    714 356 5145
    enviousdetailing@gmail.com
    Facebook connect

  6. #6
    Bader.Abbas's Avatar
    Bader.Abbas is offline Senior Member
    Join Date
    Aug 2010
    Location
    Boston,MA / Jeddah, K.S.A
    Posts
    2,201

    Default

    both look superb
    Bader @ Superior Automotive
    Audi S5 '09 Meteor Gray Magma Red
    Loud, Lowered, Carbon Fiber everywhere, 1 off steering wheel, & its 4th set of wheels on its way.

  7. #7
    Race Minded's Avatar
    Race Minded is offline Senior Member
    Join Date
    Jan 2011
    Location
    Los Angeles ✈ NYC
    Posts
    1,034

    Default

    Very nice work man!
    Only when the tide goes out do you discover who's been swimming naked - Warren Buffett

    Amat Victoria Curam - "Victory Loves Preparation"

  8. #8
    jesse's Avatar
    jesse is offline Member
    Join Date
    May 2011
    Location
    laredo,tx, usa
    Posts
    125

    Default

    nice work guys. the cars turn out super clean. kudos.

  9. #9
    Jay Slay's Avatar
    Jay Slay is online now Senior Member
    Join Date
    Feb 2009
    Location
    Home of the NY Knicks!!
    Posts
    707

    Default

    Dave..I need to get my R8 in there soon. I was looking at both those cars..if you had to choose, which would you rather have on a DD basis?

    13' Audi RS5 - let the modding beging
    13' Audi S6 - Mods to come
    12' R8 V10 Coupe
    12' Range Rover Sport GT - FOR SALE
    12' Audi A7 - Prestige/Sport/B&O (BYE BYE)
    11' Audi R8 - Ibis/Carbon/Tubi/HRE (BYE BYE)
    11' Range Sport Lux - SOLD
    10' BMW X5M - 22" HRE's - SOLD
    09' Benz C63 - SOLD

    ****instagram - ugotmopped****

  10. #10
    Plackslayer's Avatar
    Plackslayer is offline Senior Member
    Join Date
    Feb 2012
    Location
    Oklahoma City, Oklahoma, United States
    Posts
    1,489

    Default

    That is some sharp work. Well done.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Powered by scoobie.com.