My RX7 FD3S Re-Amemiya Twin Turbo Build

**Turbology** · 08-26-2012, 03:04 AM

That really is amazing, I'll never forget how much heat was coming off that exhaust. I had to do a double-take to make sure the car wasn't on fire hahaha!

Sounds like great stuff, I will definitely get some for my next build.

**Race Minded** · 08-26-2012, 08:03 PM

Originally Posted by curacaosfinest

...after a full 30 min. track session i was able to whole handed grab my downpipe and hold it with that stuff on...supposedly it has some sort of lava rock material in it...

HAHA really good to see you coming on the build and making progress! These things seem to go through spurts. You are a brave man to grab it like that bare handed I assume! It is true about the lava rock however... I used the same product many times when I needed something short term while I sort out a more permanent solution like Jet Hot (or other comparable heat coating) on a spare piece.

Do you have an ETA on the finished car at this point?

**curacaosfinest** · 08-27-2012, 02:44 AM

Originally Posted by Race Minded

Do you have an ETA on the finished car at this point?

I have to have the car done for September 29th which is Hot Import Nights Miami

so if all goes well it should be done this month!

**Race Minded** · 08-29-2012, 06:59 PM

T MINUS 1 MONTH! Looking forward to it man... proud of all the hard work!

**Turbology** · 08-29-2012, 08:32 PM

Anxiously awaiting the first start-up vid and dyno once the motor is broken in.

**curacaosfinest** · 09-01-2012, 06:03 PM

its been tough getting updates up guys

school just started so the first week is always mayhem

will be getting back to work this week

**Turbology** · 09-02-2012, 07:58 PM

No explanation necessary my man, I started teaching and grad classes again too, not enough hours in the day!

**RomZ** · 09-05-2012, 11:16 AM

amazing engine!!!

**curacaosfinest** · 09-06-2012, 04:44 PM

finally got some more work done!!

Got my injectors in...a fresh set of Five-O Injectors "Silver Bullets" 2200cc flow-matched injectors

getting these mounted properly is basically whats been holding me back from bolting everything back together

had to fab up some brackets from some aluminum...They arent the prettiest things in the world but they'll do the job just fine

i also would like to throw in that the Full Function Eng. o-ringed spacers are absolutely awesome!!
awesome fit and the customer service was great!! definitely recommend them to everyone

**Turbology** · 09-07-2012, 10:17 PM

I really like and respect your thought process throughout this build, do it right one time, the first time. Great job man!

Thread: My RX7 FD3S Re-Amemiya Twin Turbo Build

Thread Tools

Display

Posting Permissions